cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
383
Views
10
Helpful
2
Replies

Cisco ASA anyconnect 2nd connection profile not using correct DHCPpool

Havensteder
Beginner
Beginner

Hi im hoping someone can give me the golden tip to where im going wrong.

I have a existing and working anyconnect connection profile but i want to expand on this with a extra support profile. I have got so far that the clients are making a connection with there own new anyconnect profile but they are still using the default IP Pool. I have defined in the anyconnect connection profile to use the new IP pool but the clients are still receiving a IP from the existing pool.

Any tips are welcome

 

 

 

 

1 Accepted Solution

Accepted Solutions

Havensteder
Beginner
Beginner

Problem has been resolved 

View solution in original post

2 Replies 2

Havensteder
Beginner
Beginner

Problem has been resolved 

Mohammed al Baqari
VIP Advisor VIP Advisor
VIP Advisor
Hi,

Check from ASA a connected client to see which tunnel-group/group-policy is
used (show webvpn anyconnect username). Ensure that this policy is having
the right pool. If you are landing at the wrong group, check your
configuration for anyconnect profile.

**** please remember to rate useful posts
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers