Cisco ASA AnyConnect iPad Connection

[bunce.jake]

Hi,

I'm trying to get AnyConnect setup so that iPad's can connect to access network resources.

I'm receiving the following error on the iPad when I attempt to connect: AnyConnect is not enabled on the VPN Server.

Here's the configuration:

webvpn

enable outside

anyconnect-essentials

svc enable

tunnel-group-list enable

group-policy SSL-VPN internal

group-policy SSL-VPN attributes

vpn-tunnel-protocol webvpn

split-tunnel-policy tunnelall

webvpn

  svc keep-installer installed

  svc rekey time 30

  svc rekey method ssl

  svc ask none default svc

tunnel-group SSL-VPN type remote-access

tunnel-group SSL-VPN general-attributes

address-pool SSL-VPN-USERS

authentication-server-group LONDON-GLOBAL-DC

default-group-policy SSL-VPN

tunnel-group SSL-VPN webvpn-attributes

group-alias SSL-VPN enable

And an ip local pool has been created.

Any suggestions?

Regards,

Jake

[efirestone]

I am having the same issue.  I have installed the AnyConnect mobile license and all works fine when I have authentication pointed to the local ASA database, but when I change it to RADIUS I get the Anyconnect VPN client not enabled on the VPN server.

I am guessing that this is a bug and may have been resolved in newer code.  The ASA I am working with is running 8.0(3)6 code.  I have never had this issue on an ASA running 8.2 code.

[bunce.jake]

The ASA pair I've tried this on is running 8.2. This is pointed at LDAP but I know that's working.