Cisco ASA VPN solution with existing anyconnect

[Seeker369]

Hello,

Is there any particular command which can be used to accept ASA VPN to accept existing anyconnects installed on clients ?  Because on the ASA VPN wizard it does not seem possible to move on from the anyconnect image upload step.

[Rob Ingram · Accepted solution]

Hi,

When configuring remote access you do need to specify a valid anyconnect image located on the ASA appliance. However a client can connect using an older AnyConnect client. Be aware that the client could automatically upgrade the client, unless the client has been specifically configured not to automatically upgrade.

HTH

[Seeker369]

Sure , thank you !