I have read this link which is the title of my conversation: http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080103ed0.shtml. The remote site will be connected via the hub PIX outside interface but not necessarily be a PIX itself. I know the only way for the VPN client to connect to the remote site via the hub PIX is to terminate on a differenet interface than the outside hub PIX interface where the remote side will terminate its VPN.
Questions
1. Can I terminate another VPN tunnel on the inside interface of the 506E?
2. If not, I would need to add a low end router to the config. If I put a 1605 behind the 506E, Could I terminate the VPN on the outside interface of the PIX, hop to the 1605 behind it, redirect back to the PIX and then go through the tunnel to the remote site?
Thanks,
RJ
