Config IPSEC between IOS(Cisco switch 6509)and Cisco VPN client?

[frank_hsu]

Sorry!!!

Did someone have Configure IPSEC between IOS(Cisco switch 6509)and Cisco VPN client?

I can configure IPSEC between IOS router(2621)and Cisco VPN client . Cisco 6509 will drop packet on the vlan where crypto map applied.

Would somebody help me !!!!

[frank_hsu]

Sorry!!!

6509 IOS image is 122-14.SY4

[brian.kwitchoff]

Where do you have your crypto connect statement? I am assuming you are using a VPN services module on the 6509. If this is correct, you need the bump in the wire to put the VPNSM in the data path. The VLAN that is directly connected to the outside should have nothing configured on it except the crypto connect vlan## statement. The VLAN## is the the VLAN that will contain the IP address that is routable to the outside and will also have the crypto map statement.

[frank_hsu]

Dear Sir:

Thanks! We have a VPN services module on the 6509.

But we have two questionas.

One:If we didn't install VPN services module and we had crypto map statement on a interface VLAN ,the interface VLAN will drop some packet(about lose 50% test by ping from a PC on same subnet).I can connect it by using cisco vpn client,but it will autodisconnect quickly. But same config on cisco 2621 router ,everything is OK.

TWO:If we install VPN services module and we configure 6509 by the document wrote from cisco,the result is same as ONE.

Many thanks of your help!!!!