Configuration of WS-SVC-IPSEC-1 on Cat6500 when you have a WS-SVC-FWM-1

[knudsen-s]

Hi,

I have a problem, I can t figure out how to configure the WS-SVC-IPSEC-1 blade when I have a WS-SVC-FWM-1 in same 6500. The problem is I cannot make an ip address on the VLAN becouse the FWM is protecting the VLAN. Do anyone have an idee how you can get these to work together.

[#2]

In routed port mode setup, the port VLAN configuration is handled by the VPN module and is transparent to the user. This means that only the interface VLAN configuration is done by the user.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800cdfc9.shtml