Configuring dual-PRI connections ... CoNNectivity

[rkendrick_2]

I am trying to get PointA to communicate to PointB over 2 PRI interfaces. I use DDR with individual dialers (1 & 2). When I configure [dialer remote-name IRV-DR1000] on dialer 1, the router does not allow me to configure the same remote name on dialer 2. The same problem exists on the remote end. How do I configured PointA's 2 PRIs to call PointB's 2 PRIs. The configs are attached.

[s-sheffield]

Hi

you will probably need to multilink the d channel interfaces together (serial x/x:x).

The link below talks about creating a multilink interface and binding the serials to it.

http://www.cisco.com/univercd/cc/td/doc/product/aggr/10000/10ksw/mlppos.htm

hope this helps

[Marwan ALshawi]

try to use dialer rotary-group

see the following example from cisco.com

The following example configures ISDN PRI on the appropriate interfaces for IP dial-in on channelized T1:

! T1 PRI controller configuration

controller T1 0

framing esf

linecode b8zs

clock source line primary

pri-group timeslots 1-24

!

controller T1 1

framing esf

linecode b8zs

clock source line secondary

pri-group timeslots 1-24

!

interface Serial0:23

isdn incoming-voice modem

dialer rotary-group 1

!

interface Serial1:23

isdn incoming-voice modem

dialer rotary-group 1

!

interface Loopback0

ip address 172.16.254.254 255.255.255.0

!

interface Ethernet0

ip address 172.16.1.1 255.255.255.0

!

interface Group-Async1

ip unnumbered Loopback0

ip tcp header-compression passive

encapsulation ppp

async mode interactive

peer default ip address pool default

dialer-group 1

ppp authentication chap pap default

group-range 1 48

!

interface Dialer1

ip unnumbered Loopback0

encapsulation ppp

peer default ip address pool default

ip local pool default 172.16.254.1 172.16.254.48

dialer in-band

dialer-group 1

dialer idle-timeout 3600

ppp multilink

ppp authentication chap pap default

the ajust it to fit ur requerment