07-20-2016 01:40 PM
I have 10 Mbps link.. Out of that 10 Mbps I would like to use 2 Mbps bandwidth for one of my Site-to-Site VPN.
Will it be possible & how?
Could you please explain & share some material, if any.
Thank you very much in advance!
07-20-2016 03:56 PM
It depends on what devices you have to work with. Each has different capabilities and limitations. Let us know what is at each end and whether you have access to the upstream device at each end.
Ideally you would have the ability to do traffic shaping and/or policing using Quality of Service (QoS).
07-25-2016 11:40 AM
Hello Marvin,
Thanks for your reply.
My side VPN is terminated on ASA5520 Software Version 9.1(6) & using Cisco ASR1002 as a perimeter WAN device.
DO not have any information about remote/customer end devices.
ASA5520 - Software Version 9.1(6)
Cisco ASR1002 - IOS: adventerprisek9 Version 15.3(2)S
07-25-2016 07:29 PM
The easiest way would be to configure traffic policing on your ASR.
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/qos_plcshp/configuration/xe-3s/qos-plcshp-xe-3s-book/qos-plcshp-oview.html
Use an ACL with the match being the destination peer IP address.
07-27-2016 06:06 AM
Hello Marvin,
Thanks for the valuable direction.
Best regards;
Nishikesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide