Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
roblem statement: Getting unexpected client environment hop IP (hope 3 6.6.6.6 from below trace) in traceroute path even traceroute not yet reached to client environment. In my network I don't have 6.6.6.X IP subnet, still getting that hop in my envi...
In our DC we have connection between TWO devices via 10Gbase-SR-S module. |-------------| |---------|| ASR |-------------------| Nexus3K |------> Link Going to other devices to reach to internet.|------...
I have 10 Mbps link.. Out of that 10 Mbps I would like to use 2 Mbps bandwidth for one of my Site-to-Site VPN.
Will it be possible & how?
Could you please explain & share some material, if any.
Thank you very much in advance!
This is about NAT on ASA.
I would like to know about TWICE NAT/ DESTINATION NAT. I know about STATIC NAT, but confused about TWICE NAT/ DESTINATION NAT.
Not sure when TWICE NAT/ DESTINATION NAT required in network. Is there any criteria or specific c...
Hello Everyone,
I have query related to IKEv1 to IKEv2 feasibility.
Currently I am using ASA5540 with Software Version 9.1(6)11.
On this ASA we are using IKEv1 and having almost 240 Active SA/tunnels.
Now I have received request to change IKEv1 t...
Hello @balaji.bandi - Thanks for your inputs!!Actually this issue is in my production environment, due to that I cannot post the configuration here.However, return trace is fine and not seen any issue with it.The problem is that 6.6.6.X subnet not ev...
Thanks for the information.. However it was working with same MTU setting and without any issue before 10th July 2019, this input error started from 10th July only. Not sure what went wrong. Also the MTU 9154 is setup on all our DC devices or globall...
Hello Marvin,
Thanks for your reply.
My side VPN is terminated on ASA5520 Software Version 9.1(6) & using Cisco ASR1002 as a perimeter WAN device.
DO not have any information about remote/customer end devices.
ASA5520 - Software Version 9.1(6)
...
Yes, this is only command normally used. It will show all the configured object-groups (Network, Service & other) on the device.
Still if you want to get selected type of object-group out put, you can also use,
"sh run object-group network | in objec...
