Does this design work?

[nelsonlin]

Two 1841 routers connecting to each other over with WIC-1AM modules. Is it possible to run bridging on all the FastEthernet and Async interface? Is there any example configuration?

Any advise is appreciated!

[jackyoung]

I did not test this module / bridging and you better to test the command in router physically.

Could you advise why require bridging ? You have to clarify the access-list to allow in the dialer connection.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00806c5807.html

Hope this helps.