Dynamic-to-Static IPSec with NAT with VPV client

[josephpang]

With reference to the Router-to-Router Dynamic-to-Static IPSec with NAT sample config site “ http://www.cisco.com/warp/public/707/ios_804.html , Any one could advise me if I would like to add the vpn tunnel for the mobile VPN client for the my HQ.

Thanks in advance

Joseph

[edadios]

This might be what you are looking for.

This sample uses vpn3 client.

http://www.cisco.com/warp/customer/471/ipsecrouter_vpn.html

Regards,

[josephpang]

Thanks for your reply. This sample config is very close to what I need to setup, except that my remote site is using the dynamic ip assigned by the ISP and I would like to allow the NAT on the HQ router so that my users in HQ able to browse internet as well. do you have sample config like that?