Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have found this workable cisco 1841 config on the NET. From this link: http://unifi.athena.my/config/cisco1841.txt But it is doing source NAT from FA0/1 to Fa0/0. If we need to bridge, is it need to use “ip unnumbered”?See my config below” 1...
I have a customer using the Eriksson MD110 with E1card running on MFCR2 Signal. We would like to test on Cisco2620XM with the vwic-1mft-e1 with the aim-voice-30 to integrate with the PBX box.Is the MFCR2 a propriety signaling by the Eriksson? Is Cisc...
My customer has a Pix 520 with 4 interface card attached. Is the version 6.21 compatible with PIX520 and all the accesory cause we planning to upgrade the flash file.Thanks in advance.
Hi,I encounted a problem when I plug in the Cisco wireless adaptor 352 to my compaq notebook model M300, the system will halted at boot up. Any one could advise me what is happening.Operation System : Windows NT with SP 6.Thanks in advance
With reference to the Router-to-Router Dynamic-to-Static IPSec with NAT sample config site “ http://www.cisco.com/warp/public/707/ios_804.html , Any one could advise me if I would like to add the vpn tunnel for the mobile VPN client for the my HQ.T...
I just went to the online configurator. When I put in 2 PIX-4FE to the 525R PIX., the system prompt me you are only allow to add in 6 more interface. So I think the solution might not work..One more thing. Is the 525R support more than 3 interface? F...
Thanks for your reply. This sample config is very close to what I need to setup, except that my remote site is using the dynamic ip assigned by the ISP and I would like to allow the NAT on the HQ router so that my users in HQ able to browse internet ...
