10-18-2024 04:27 PM
Hi there,
I want to know the IP pool usages on the Firepower for Remote Access VPN users.
From the CLI (via system support diagnostic-cli), I can do:
show ip local pool [pool name]
The 'ask' is if there is other ways to get this info?
Does this info available in the FMC web UI?
How about doing custom SNMP polling? Is there a MIB for this?
Any suggestions?
Thanks.
10-18-2024 07:25 PM
@raymng hi, as per below thread its bit complicated and recommends to use CLI. i am not sure about FMC. also new devices, you can use the python libraries to get CLI output or use tool like ansible.
https://community.cisco.com/t5/network-management/snmp-dhcp/td-p/2946589
10-19-2024 03:04 AM
Check link
I think
Show dhcp statistics
Is solution you need
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide