Have a problem with DMVPN configuration

[tuannv17121]

Hi all,

I have a problem with DMVPN, topology as below:

The purpose of this lab is make connection from LAN remote site 1(192.168.2.1) and remote site 2(192.168.3.1) to LAN central site (192.168.1.1)

I configured DMVPN Hub and Spokes at R1,R2,R3 respectively. All configuration seems correct. From R3 and R4 I can ping to LAN-R1(192.168.1.1) OK. But on R5 and R6 I can not ping to 192.168.1.1. Besides, on R1 I also could not ping to 192.168.2.1 amd 192.168.3.1.

I already configured EIGRP between R3 and R5, R4 and R6. Additionally, On R3 and R4 I also configured static (192.168.1.1) into EIGRP:

router eigrp 10

  redistribute static metric 100 1 244 1 1500

Does anyone know the way to work out this issue? Thank you so much!

[Mark Malone]

Hi really need the configs here to check the issue very difficult to make a call without them , could you post them since its just a lab

[tuannv17121]

hi markmalone,

thank you for your cmt. The configuration I will post later because of inconvenience. But one thing I confused is: normally all Hub and Spoke configuration sample here only connect the LAN-attached to Spoke to LAN-attached to Hub. In my lab, I need to connect a LAN from other router behind the Spoke (ex- 192.168.2.1/24 and 192.168.3.1 on R5 and R6 respectively). What configuration is needed to overcome this. My solution is here and it doesnt work:

-configure eigrp between R3 with R3, R6 with R4

-redistribute static routing into eigrp on Spokes (on R3 and R4)