I want the router to be a PPTP VPN client to 2 independent PPTP servers, both are in different cities in Cisco routers. I have tested with one on cisco 1841 aqnd its working fine; but when I add the 2nd, its using vpdn-group 1 and therefore connecting to the wrong PPTP server:
here is the config for the one that works:
vpdn-group 1
request-dialin
protocol pptp
rotary-group 0
initiate-to ip xxx.xxx.xxx.xxx
!
interface Dialer0
mtu 1450
ip address negotiated
ip pim dense-mode
ip nat outside
ip virtual-reassembly
zone-member security private
encapsulation ppp
ip igmp query-interval 125
dialer in-band
dialer idle-timeout 0
dialer string 123
dialer vpdn
dialer-group 1
no peer neighbor-route
no cdp enable
ppp pfc local request
ppp pfc remote apply
ppp encrypt mppe auto
ppp authentication ms-chap-v2 ms-chap eap chap pap callin
ppp eap refuse
ppp chap hostname xxx@xxx
ppp chap password 7 xxxpassword
But if I create a vpdn-group 2 and a Dialer1 interface, with dialer-group 2, its still attempting to connect to the IP in vpdn-group 1 - how do I get it to use the 2nd vpdn-group, or how do I make this work? and which cisco 3G Router you prefer because these are remote sites and only 3G Internet service is available.
