05-02-2008 02:40 PM
Hello all. I am a newb. Just got my 1751 setup for DSL PPPoE login and am on the net with it now. Wahoooo! Next step I need to add is VPN setup for the VPN Client software. Can anyone walk me through the commands or point me to a step-by-step reference on it?
Thanks,
Mark
Solved! Go to Solution.
05-04-2008 10:41 AM
05-04-2008 10:41 AM
This is a good set of links:-
Easy VPN Client config:-
http://www.cisco.com/en/US/products/hw/routers/ps221/prod_configuration_guide09186a008007cfa7.html
HTH.
05-05-2008 05:04 AM
Andrew,
Thanks for the links. I have found that vpn guide just a day or 2 ago, and it looks relatively straight forward. I do have one question though.... and that is that all the access lists that I've seen for allowing traffic to/from is all set up for static IP addresses. I have a wic-1enet plugged into a dsl modem in bridge mode, so I had to copy a Dialer 1 Int config from someone else's post and my IP is not static. How would I change the access lists for traffic flow in my situation?
Thank you,
Mark
05-06-2008 05:44 AM
If I could rate myself, I would, but I can't. I at least want to have the post with an answered check mark so others with the same question can at least find the information I did to help them out.
Once again, I've had to answer my own post, but for others that may read on...I'll attach some links and documents that helped me.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide