Following instructions from http://www.cisco.com/en/US/products/hw/routers/ps380/products_configuration_guide_chapter09186a008045d287.html for the router and from http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a0080450bb6.html for the ASA, I have been mildly successful in setting up a VPN to my office.
Thus far, when viewing my ip routing from the router, it shows the tunnel interface as up and running, but I suspect my routing is screwed up. Are there better instructions someplace other than these documents?
They seem pretty straight forward, but some of the instructions don't seem to match previous configuration ip addresses.
Any help is appreciated. I can post modified configs if necessary.
Nelson
