Is there any command for disconnect session in Cisco1900(RAS)

[pegasusjwon]

Good day. 

I am using a Cisco 2600(RAS) device for remote access from my office.

I certainly know that disconnect session would be Ctrl + Shift + 6 + C(X) after connect any device via RAS.

However, I hope to know is there any way to disconnect session for return to RAS by COMMAND?(NO Ctrl stuff)

Because Ctrl stuff is a little bit annoying in some case.

Thank you!

[Georg Pauwen]

Hello,

'show sessions' shows you the active sessions with a corresponding number. The exec command 'disconnect' followed by the number of the session you want to disconnect ends that specific session.

Is that what you are looking for ?