Issue Adding VPN to PDM

[aftermath]

I would like to add VPN to PDM, but I do not know the order of events to do so ( seem to be drawing a blank here ). I want to do this using PDM, not the CLI.

Example, if I had an IP of 24.54.2.xxx, and pre-share of gus8790, and a LAN IP of 172.115.26.xxx.

What would be the order ( using tabs in PDM ), that this information would be entered?

thank you..

[Patrick Iseli]

I suggest you to use the VPN wizard. The wizard will guide you through the VPN configuration.

This work fine if your VPN config is not to complex and consists in just one VPN Site 2 Site or Remote VPN. Otherwise I suggust you to invest a little bit of time in the command line.

1.) Open your PDM and choose in the Wizards Menu

2.) Then the VPN Wizard

Take also a look in the Configuration example page:

http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Hardware:PIX&s=Software_Configuration

sincerley

Patrick