03-29-2007 05:30 AM - edited 02-21-2020 02:57 PM
I have a scenario as shown in the attachment "lifeline_routning.jpg". Two sites with several VLAN's is connected over a wireless bridge. The green VLAN is for administration of network devices. If the wireless bridge breakes down, I would like the Cisco 851 router to establish a VPN through a GPRS unit to the main site for the administrative VLAN.
The SnapGear VPN router at the main site uses MSCHAPv2 authentication.
I have enabled PPPoE on the 851, and I have configured a dialer interface with MSCHAPv2 authentication.
What I dont know, is how I configure the dialer interface to connect to the remote public WAN ip address of the Snapgear ? Should I configure a dialer map ? Is this acheived through a access list ? Or maybe VPDN ? Is there any documentation with examples on this kind of setup ?
Network layout and running-config is attached.
04-04-2007 06:14 AM
Unique to EAP-FAST, phase zero is a tunnel-secured means of providing an EAP-FAST end-user client with a PAC for the user requesting network access.Providing a PAC to the end-user client is the sole purpose of phase zero. The tunnel is established based on an anonymous Diffie-Hellman key exchange. If EAP-MSCHAPv2 authentication succeeds, CiscoSecure ACS provides the user a PAC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide