Permit to certain telephone numbers to dial-up to a RAS

[yboul1234]

I want to set up a remote access server with one wic-2am and one wic-1b-s/t cards.

I would like to know if it is possible to configure the router to accept calls only from particular telephone numbers.

Thanks in advance

[Georg Pauwen]

Hello,

for the ISDN connections, you could use the 'dialer caller' (or 'isdn caller' for legacy dialer profiles); not sure if something similar exists for analog connections...

dialer caller

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_d1g.htm#wp1120901

isdn caller

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_i2g.htm#wp1052104

HTH,

GP

[yboul1234]

Thanks a lot for the reply.

I would be grateful if anyone knew something similar for the analog connections as well...

[Aaron]

No analog modem interface, on any Cisco router, provides any way to monitor or control on the basis of analog CLID. This includes the WIC-xAM.

If you want to do CLID screening on calls from analog modems, you'd need to have those calls come into a digital modem module (which would require using a digital interface into the circuit network, such as BRI or PRI.)