Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cme v.3.1 on a 2801 router running IOS 12.3(8)T6. The problem I'm facing is that all the calls (local, long distance, to mobile etc.) are serviced with no problem, apart from international calls from some countries that are not delivered to ...
Hi,I have a simple configuration. An ADSL modem and an access point that acts as a dhcp server for the wireless clients. The problem is that the access point does not advertise the dns servers that are configured at the adsl modem to wireless clients...
I want to set up a remote access server with one wic-2am and one wic-1b-s/t cards. I would like to know if it is possible to configure the router to accept calls only from particular telephone numbers.Thanks in advance
I have a ccme running on a 2801 router with a vic2-2bri-nt/te on it, but although I have configured it and I can make calls from my ipphone to PSTN I cannot receive calls originating from the PSTN. Does anyone know if I have to make a dial-peer for t...
I applied the translation rule with no luck. I also tested it to see if it worked ok. So the incoming called number, is indeed translated to a phone extension but obviously the router is not able to forward the call to the phone, because when I call ...
My topology, is ISDNline-->netmode-->router-->switch-->ipphones (no pbx).The only thing my provider is sending me, as I can see from "debug isdn q931", is a ten digit number for the isdn line, lets say 1234567890. Then I' m trying to forward the call...
Thanks for the reply, I have already tried to configure a voip dial-peer like this:dial-peer voice 10 voipdestination-pattern 1.. (my extensions)session protocol sipv2session target ipv4:x.x.x.x (router's IP where ccme resides)dtmf-relay rtp-ntecodec...
