QuickVPN win7 64 without windows firewall

[rohitgorasia]

I have an RV042 setup for quick vpn access.

The remote computer in question is a win 7 64bit. The PC uses McAfee SAAS firewall. This disables the windows firewall.

1. I can connect to the vpn with SAAS disabled and windows firewall enabled.

2. I cannot connect to the vpn with both windows firewall and SAAS disabled.

3. I cannot run SAAS and windows firewall together to check if this would work.

So from my understanding of the above statements I need to figure out what windows firewall is doing to allow the vpn to connect, and so how do this with windows firewall disabled. I can then leave the windows firewall disabled and enable McAfee SAAS.

The message quickvpn provides when it fails to connect is that the remote gateway is not responding. The client logs show that the tunnel had been opened but it was unable to ping.

Can anyone shed light on the matter?

Many Thanks

[Herbert Baerten]

Hi Rohit,

since this question is about a product in the Cisco Small Business / Linksys range, I suggest you move it to the community, where you will have a better chance of getting expert advice.

best regards,

Herbert
Cisco Moderator

[rohitgorasia]

Thanks herbert,

I think I am tending to move away from QuickVPN.

Cheers,

Rohit