cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1185
Views
0
Helpful
4
Replies

Remote acces VPN Cisco 1811

shivudu1984
Level 1
Level 1

Hi forum

My question is very simple. At my office we have a Cisco 1811 router that is connected to our internal network. Dialer0 is connected to our ISP. We have a IPSEC tunnel running between one of the branch offices at a different location. Our 1811 is not a mainstream and we have a different firewall for the remote users. But the problem here is one of the workstations that's a MAC book would not connect to our firewall so i had to put him through 1811 to access our internal resources.

Since i am running an IPSEC tunnel on the dialer0 interface how do i configure Client access VPN and how do i map it to the dialer interface.

Your help is greatly appreciated

Thanks

2 Accepted Solutions

Accepted Solutions

Todd Pula
Level 7
Level 7

Attached is a sample configuration that you can use to service both static site-to-site and dynamic remote access on the same router.  Please let me know if you have any specific questions.

View solution in original post

IOS support for direct LDAP integration was recently released in 15.1.  You can read more about it at the link below.  Information regarding DHCP integration can be found at the second link.

http://www.cisco.com/en/US/docs/ios/sec_user_services/configuration/guide/sec_cfg_ldap.html

http://www.cisco.com/en/US/customer/docs/ios/sec_secure_connectivity/configuration/guide/sec_easy_vpn_srvr_ps10592_TSD_Products_Configuration_Guide_Chapter.html#wp1519064

View solution in original post

4 Replies 4

Todd Pula
Level 7
Level 7

Attached is a sample configuration that you can use to service both static site-to-site and dynamic remote access on the same router.  Please let me know if you have any specific questions.

Thanks for your help. Let me go through the file and will get back to you

hi

i have not had a chance yet to run the config. but i have a  new problem. how can i integrate my windows active directory users to  access remote access vpn rather than adding users manually. and also i want my domain controller (which is also my dhcp server) to lease out the ip addresses.

IOS support for direct LDAP integration was recently released in 15.1.  You can read more about it at the link below.  Information regarding DHCP integration can be found at the second link.

http://www.cisco.com/en/US/docs/ios/sec_user_services/configuration/guide/sec_cfg_ldap.html

http://www.cisco.com/en/US/customer/docs/ios/sec_secure_connectivity/configuration/guide/sec_easy_vpn_srvr_ps10592_TSD_Products_Configuration_Guide_Chapter.html#wp1519064