02-01-2006 08:52 AM - edited 02-21-2020 02:13 PM
Hi,
Remote access vpn configuration is done on the pix 506E. I am got the ip address 172.16.1.1 the pool defined in the configuration, the gateway showing as 172.16.1.1..I cannot able to telnet and access anything inside. I am attaching the config.Please help me to resolve the same, this is very urgent.
Thanks in advance,
Regards,
Ram
02-01-2006 04:33 PM
apply the command "isakmp nat-traversal 20"
02-01-2006 11:35 PM
Hi,
Thanks for the update. Please let me know any config error was there. Now we are facing another problem, mails are not accessable from the outside through web.Please help me to resolve the same.
Regards,
Ram
02-02-2006 02:44 AM
Hi,
I still facing a probelm. I cannot able to do the telnet from inside after coming to the inside with the pool.Please help me to resolve the same.
This very urgent. Please help me.
regards,
Ram
02-02-2006 04:28 AM
On your 506, in config mode do: management-access inside, now you'll need to allow telnet access for your ip pool, i.e.
In config mode: telnet 172.x.x.0 255.255.255.0 inside
Now if you connect you using your vpn clinet to the pix, you should be able to ping the inside interface of the pix plus also telnet to the pix on the inside interface.
PS. Also add: isakmp nat-traversal (in config mode) and save all with: write mem
Hope this helps,
Jay
02-02-2006 09:36 PM
Hi,
Thanks alot for your help. It is perfectly working fine.
Regards,
Ram
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide