08-15-2008 08:27 AM - edited 02-21-2020 03:53 PM
What could be the problem for getting the error when trying to connect to VPN gateway through client,
6|Aug 15 2008|16:51:22|302014|19.67.104.226|60.71.2.5|Teardown TCP connection 327321 for outside:19.67.104.226/28807 to NP Identity Ifc:62.70.2.53/10000 duration 0:00:04 bytes 0 TCP Reset-I
08-17-2008 03:21 AM
This means that your clients are using IPSEC over TCP (Port 10000) to connect to the VPN GW. However the higher security level interface (represented by 'I' in Reset-I) is sending a reset to close the connection. This is usually normal (as one side is requesting to close the TCP session), perhaps it does not need it any longer.
If your VPN is not working, you would be better of running an isakmp/ipsec debug then worrying too much about this syslog.
Please rate if helpful, Regards
Farrukh
08-18-2008 01:59 PM
How to go about for fixing this? and allow the client establish connection with vpn box
08-18-2008 09:23 PM
Post your configuration and debugs for both Phase1 and 2.
Regards
Farrukh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide