remove FEX interface from Cisco 6880 IA

[jm.virtual01]

in my network, previously we were using 4 Cisco 6880 IA and we have assign proper FEX interface on these switches. Now we have removed one switch from there but in the configuration for 4thFEX is still there, i want to remove it but without switch reload ?

Do anyone has any suggestion ?

One more question regarding this switch, previously we are using some specific credentials to login into the switch now i want to change it and use the network credentials to login into the switch ?

any one can login in the switch with there network credentials from specific group but i don't want to reload the switch. 

Do any one has any suggestion regarding this ? 

[Flavio Miranda]

Hello @jm.virtual01

About FEX you could put the config here. I think there's a command " no fex associate".

 About log in using network credentials you need a RADIUS or TACACS like cisco ISE or ACS. Then you can integrate it with your Active Directory.

[jm.virtual01]

For FEX,
here is my configuration:
module provision fex 115
slot 1 slot-type 387 port-type 61 number 48 virtual-slot 55
slot 2 slot-type 387 port-type 61 number 48 virtual-slot 59
slot 3 slot-type 387 port-type 61 number 48 virtual-slot 60
slot 4 slot-type 387 port-type 61 number 48 virtual-slot 58
!
i want to remove the slot 4. It is not connected at this moment.

[Flavio Miranda]

Have you tried no fex associate 58 ?

[jm.virtual01]

yes, it doesn't work.

[jm.virtual01]

I want to remove only slot 4 from FEX 115 provision without reload the switch.

slot 4 slot-type 387 port-type 61 number 48 virtual-slot 58