Reverse Telnet

[kradjesh13]

I really can't understand the concept of reverse telnetting.

I really get confused to know why is it used ??

While using it whare the configuration are stored ?? either in the router or in the modems memory

I am just waiting for a clear explination from you.

Thanks in Advance

Rajesh

[zahmed]

Rajesh,

Generally it is used to talk and configure a modem connected to a router's async port with AT commands.

So if you end the AT strings with &w , only then the AT strings get stored in modem's NVRAM. Otherwise its not stored anywhere.

Read the following for more on that :

http://cco/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800871ec.html

Thanx and Regards,

~Zulfiqar

[kradjesh13]

The above given link is not working... can u plz check and once again give me a correct link.

Rajesh

[zahmed]

My mistake - should have replaced cco by www.cisco.com:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800871ec.html