I am trying to setup AnyConnect on a ASA 8.2.5 from scratch. I can get connected and dont see any errors. Not able to ping the inside interface or the device I have attached to the inside interface. From the ASA, I can ping the device attached to the Inside interface of the ASA. Ths would appear to indicate a problem with the ASA configuration for Anyconnect It has to be something simple but so far it eludes me. I have turned up logging and can see verification that the anyconnect session successfully connections. No errors are showing.
Here is the partial config that I am using -
access-list no_nat extended permit ip 10.34.110.0 255.255.255.0 10.34.250.0 255.255.255.0
access-list no_nat extended permit ip 10.34.250.0 255.255.255.0 10.34.110.0 255.255.255.0
access-list Outside1_to_Inside extended permit ip 10.34.250.0 255.255.255.0 interface Inside
access-group Outside1_to_Inside in interface Inside
ip local pool SSLClientPool 10.34.250.1-10.34.250.25 mask 255.255.255.0
icmp unreachable rate-limit 1 burst-size 1
icmp permit any Inside
nat (Inside) 0 access-list no_nat
access-group Outside1_to_Inside in interface Inside
route Outside1 0.0.0.0 0.0.0.0 68.70.82.57 254
crypto ca trustpoint localtrust
enrollment self
fqdn sslvpn.mydomain.com
subject-name CN=sslvpn.mydomain.com
keypair sslvpnkeypair
crl configure
ssl trust-point localtrust Outside1
webvpn
enable Outside1
anyconnect-essentials
svc image disk0:/anyconnect-win-2.5.2014-k9.pkg 1
svc enable
tunnel-group-list enable
group-policy SSLClientPolicy internal
group-policy SSLClientPolicy attributes
dns-server value 8.8.8.8
vpn-tunnel-protocol svc
default-domain value ssl.mydomain.com
address-pools value SSLClientPool
Any suggestions would be appreciated.
Ron
