Setting up VPN on 2811

[vdalehubbard]

Greetings

I need to setup VPN on my 2811 router but I can not. I go to use the VPN section on the SDM and it states:

IPSec/VPN unavailable.

The IOS image in your router does not support the requested feature. To configure this feature, you need to go to the Software Center on Cisco.com and upgrade your IOS image to one that supports this feature set.

I am using SDM 2.1.1 with IOS Version 12.3(8)T6

Any help as to what I do to start configure VPN is appricated.

[mchin345]

To configure IPsec VPN you requre an IOS that supports one of the encrypton protocol. You need a IOS image that has a 'k' in the name which means it supports either DES or 3DES which is required for IPsec VPN to work.