Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
GreetingsI need to setup VPN on my 2811 router but I can not. I go to use the VPN section on the SDM and it states:IPSec/VPN unavailable.The IOS image in your router does not support the requested feature. To configure this feature, you need to go ...
I have two DSL lines coming into a 2811 router. Due to helping out with bandwidth, I need to seperate groups of internal IP addresses and assign them to different gateways (DSL lines). I want to ask what commands I need to use to do this. Here is my ...
Greetings,I have two DSL lines coming into a 2811 router. Due to helping out with bandwidth, I need to seperate groups of interneal IP addresses and assign them to different gateways (DSL lines). I want to ask what commands I need to use to do this...
GreetingsI just added a new fastethernet interface to my 2811 router. The lights come up fine when you plug something into and everything. But it doesn't show up in the IOS or when you do a show configuration. Here is my info:IOS Version 12.3(8)T4...
GreetingsI installed a new FastEthernet interface on my 2811 router. The lights are on saying it has connection, but the IOS acts like it's not there. The interface doesn't show up to edit or anything. Any suggestions?
I have these internal address:192.168.1.1192.168.1.3192.168.1.4192.168.1.5192.168.1.29192.168.1.32192.168.1.38192.168.1.62I want those to go to the **.**.**.*22 gateway.Everything else:192.168.1.6 - 192.168.1.28192.168.1.30 - 192.168.1.31192.168.1.33...
I don't care what the provider needs to know to route, I just want this to work.I put NAT on the route like suggested and so I did a pool of the IP address I had left. I just need to know what I need to do to get this to work. So, NAT on the route ...
The 206.**.**.*22 is the other DSL modem, which the extra card did not work.The nat configuration was the left over IP addresses that I had from the ISP. I didn't "*" out the 215 on acident, and so it is 215 to 220 in my NAT configuation. So, my po...
Sorry for the late response, was on vacation last week.Well, I checked over that and it made sense but I'm still getting the same result. Here is my configuration on my router:version 12.3service timestamps debug datetime msecservice timestamps log ...
