cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2523
Views
5
Helpful
6
Replies

Site to Site VPN between PIX and Linksys RV042

Gary Jackson
Level 1
Level 1

I am trying to create a vpn tunnel between a PIX 506E and a Linksys RV042.  I have configured Phase 1 and Phase 2 as well as the transform set and interested traffic and tied it to the outside interface but it will not create the tunnel.  The configurations are as follows:

PIX 506E running IOS 6.3

isakmp policy 40 authentication pre-share
isakmp policy 40 encryption 3des
isakmp policy 40 hash sha
isakmp policy 40 group 2
isakmp policy 40 lifetime 86400
isakmp key ******** address 96.10.xxx.xxx netmask 255.255.255.255
access-list 101 permit ip 192.168.21.0 255.255.255.0 192.168.1.0 255.255.255.0crypto map Columbia_to_Office 10 ipsec-isakmp
crypto map Columbia_to_Office 10 match address 101
crypto map Columbia_to_Office 10 set peer 96.10.xxx.xxx
crypto map Columbia_to_Office 10 set transform-set ESP-3DES-SHA
crypto map Columbia_to_Office interface outside

Linksys RV042

Local Group Setup
     IP Only
     IP Address: 96.10.xxx.xxx
     Local Security Group Type: Subnet
     IP Address: 192.168.1.0
     Subnet Mask: 255.255.255.0

Remote Group Setup
     IP Only
     IP Address: 66.192.xxx.xxx
     Remote Security Group Type: Subnet
     IP Address:  192.168.21.0
     Subnet Mask: 255.255.255.0

IPSec Setup
     Keying Mode: IKE with Preshared key
     Phase1 DH Group: Group2
     Phase1 Encryption: 3DES
     Phase1 Authentication: SHA1
     Phase1 SA Lifetime: 86400
   
     Phase2 Encryption: 3DES
     Phase2 Authentication: SHA1
     Phase2 SA Lifetime: 3600 seconds
     Preshared Key ********

I am a bit of a novice on VPN. Thank you in advance for your expertise.

1 Accepted Solution