- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2012 11:11 AM
Hi:
Can I on the same PC open an IPSEC tunnel then an SSL tunnel using anyconnect. ( tunnel over Tunnel)
Can I on the same PC open an SSL tunnel over another SSL tunnel using Anyconnect.
Thanks
Ben
Solved! Go to Solution.
- Labels:
-
Remote Access
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-26-2012 07:17 PM
Yes, you are right.
You can't use AnyConnect to open both IPSEC and SSL VPN.
But you can use Cisco VPN Client for IPSec and AnyConnect for SSL and that would work.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2012 08:29 PM
Yes, you should be able to connect to IPSec tunnel then SSL tunnel after that.
For SSL over SSL tunnel, i don't believe you can do that because once you are connected to AnyConnect to the first tunnel, there won't be option for you to connect to another SSL VPN peer as the box will be greyed out.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-26-2012 07:07 AM
Thanks for replying.
In our case we wanted to use anyconnect to open both IPSEC and SSL.
So I guess this is not possible.
And if we use the cisco vpn client for IPSEC and anyconnect for ssl it would work.
Can you confirm if the above is correct.
Thanks for your feedback.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-26-2012 07:17 PM
Yes, you are right.
You can't use AnyConnect to open both IPSEC and SSL VPN.
But you can use Cisco VPN Client for IPSec and AnyConnect for SSL and that would work.
