Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi:Anyone has any idea why my SSL connections gets disconnected after 40 seconds.The checkpoint IPSEC remains connectedI close Anyconnect and retry. It will connect and disconnect again after 40 secs.Thanks
Hi:Can I on the same PC open an IPSEC tunnel then an SSL tunnel using anyconnect. ( tunnel over Tunnel)Can I on the same PC open an SSL tunnel over another SSL tunnel using Anyconnect.ThanksBen
Hi:My syslog server is not receiving any log. Locally I can see the log.Here is my config:logging logfile customer1 6 size 65536logging server 10.10.10.10 6 use-vrf defaultlogging timestamp milliseconds I can ping the server from the nexus.Thanks
Need help badly.I have 2 nexus 5596 in VPC mode. Each one has a blade switch connected to it.blade1--Nx1---Nx2----Blade2Nx1 and Nx2 can ping management address on Blade2Nx1 and NX2 cannot ping blade1. Nx1 see blade1 in cdp nei table.Nx1 shows Blade1 ...
Thanks for replying.In our case we wanted to use anyconnect to open both IPSEC and SSL.So I guess this is not possible.And if we use the cisco vpn client for IPSEC and anyconnect for ssl it would work.Can you confirm if the above is correct.Thanks fo...
Jerry:Yes it is L3 5596.IP Interface Status for VRF "default"(1)Interface IP Address Interface StatusVlan400 10.38.107.2 protocol-up/link-up/admin-up Vlan404 10.18.80.3 protocol-up/link-up/admin-up...
Thanks. I will be able to try this in the lab in 3 weeks.In VSS there is only one loopback and in standalone there are 2 loopback ( one for each device).So I gues I will have to do some manual manipulation to restore exactly as the originals.
Thanks.Rajiv: When I convert to standalone will the switch returned to its orriginal config or do I have do it manually.The link above is not detailed enough.Thanks again.
