Static route to L2L tunnel

[csondergaard]

Hi,

Got a problem routing trafic to my L2L tunnel...

Got an ASA5505 Sec+ with ip 10.45.10.1 on inside interface. Firmware 8.3(1)

Got another Cisco router (From my ISP) with ip 10.45.10.254 - This one creates an L2L tunnel - To the 10.45.20.0/24 net.

On the 5505 ive got "route inside 10.45.20.0 255.255.255.0 10.45.10.254 1", and trafic is being directed to 10.45.10.254 as it should.

I know cause I can ping everything one the 10.45.20.0/24 net - But thats it... Cant RDP, connect to fileshare... Nothing.

When i test a PC and set it to gateway 10.45.10.254 I can access everything on the remote network.

Do I need some NAT command or an access-list?

I've setup AnyConnect VPN on the ASA and I can connect to both networks without any problems...

Thanks in advance!

Best regards

Carsten

[PAUL GILBERT ARIAS]

can you give more details and draw a topology?

The inside of the ASA is 10.45.10.1 a router connected to the inside 10.45.10.254, behind this router a network 10.45.20.0/24, correct?

What is the internal LAN of the VPN peer?

Cna you attach a sanityzed config?

[csondergaard]

Site1: 10.45.10.0/24

10.45.10.1 is the ASA 5505 with internet access

10.45.10.254 ME3400 Router (Only provides the L2L link - No internet)

Site2: 10.45.20.0/24

10.45.20.254  Cisco ME3400 Router

Config from ASA5505 is attached... I know its not complete yet :-)

Thanks!

Best regards

Carsten