Stuck out of Access Server (2511)

[smcline06]

I have setup an Access Server (AS2511RJ) and am accessing this via console (No WAN/Eth) though when I connect to another device from this Access server I am unable to back-out of said device. I have used the Ctrl+Shift+6 X command and it will show me the AS2511 though whenever I enter a command it goes back to the remote device.

Ex. I connect from the AS2511 to 2650 router. I am unable to Logout/Exit/Ctrl+Shift+6 X from the 2650 and get back to the AS2511. Is there a way I can auto timeout the connections say after 5 minutes of inactivity it will close all Async lines?

[smcline06]

HA Figured it out (^_^)

Cisco3640#^^x

Access_Server#

[Resuming connection 1 to cisco3640 ... ]

disconnect

disconnect

% No current connection

Cisco3640#^^x

Access_Server#

[Resuming connection 1 to cisco3640 ... ]

clear line 1

clear line 1

% Line 1 not available for clearing [OK]

Cisco3640#^^x

Access_Server#

[Resuming connection 1 to cisco3640 ... ]

Cisco2650-2

Cisco2650-2

Translating "Cisco2650-2"...domain server (255.255.255.255)

Translating "Cisco2650-2"...domain server (255.255.255.255)

(255.255.255.255)% Unknown command or computer name, or unable to find computer address

Cisco3640#^^x Disconnect

Access_Server# Disconnect

Closing connection to cisco3640 [confirm]

Access_Server#

Correct command, all needed to be on 1 line!