05-31-2010 05:47 AM
Hello,
I was trying to set terminal server using NM-16A module in Cisco 2651XM router but no luck. I did use 2511 in the past without any issue but i don't know if i'm not doing anything wrong with this module as i never set terminal server with this module before. Initially i thought my NM-16A is bad but when i do "sh ver" then router shows 16 Terminal Lines. All i get connection refused by remote host when i try to console other device even after clearing lines. Can anyone please help?
Thanks,
Solved! Go to Solution.
05-31-2010 01:55 PM
You may want to take a look at this doc:
http://www.cisco.com/en/US/docs/ios/interface/configuration/guide/ir_nm16as.html
It has been a while since I have used the async interfaces on a 25xx series device. I have used the async mod on a 2600 and aside from setting baud rate, parity, etc. I don't recall any special issues. I have one in my lab now, but apparently I have misplaced my async octopus cables. Which is a bit disconcerting.
Anyway, hope that helps.
Regards,
Bill
Please remember to rate helpful posts.
Please remember to rate helpful responses and identify
05-31-2010 01:55 PM
You may want to take a look at this doc:
http://www.cisco.com/en/US/docs/ios/interface/configuration/guide/ir_nm16as.html
It has been a while since I have used the async interfaces on a 25xx series device. I have used the async mod on a 2600 and aside from setting baud rate, parity, etc. I don't recall any special issues. I have one in my lab now, but apparently I have misplaced my async octopus cables. Which is a bit disconcerting.
Anyway, hope that helps.
Regards,
Bill
Please remember to rate helpful posts.
Please remember to rate helpful responses and identify
06-01-2010 06:20 AM
Thank you Bill that link was helpful and it is now working.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide