Traffice is not passing through Vpn tunnel

[Amardeep Kumar]

HI ,

I have set a tunnel between Cisco pix 6.3 and Cisco Router 7200. Show Isakmp sa showing below detail on Pix

Total     : 1

Embryonic : 0

        dst               src        state     pending     created

    xx6.x71.x29.x68   x2.1x7.52.1x1    QM_IDLE         0           0

Is tunnel is UP ?

Traffice is not going throgh the tunnel . why ?

Please help.

Thanks

[mvsheik123]

Hi,

AFAIK, thats a good sign :-). Try to initiate extended ping to remote IP.  If you still have issues, make sure ACLs are correct on both ends and check further on show crypto ipsec sa.  This should give you information on packet encrypt/decrypt.

hth

MS