03-13-2014 12:00 PM
Good Afternoon,
I recently got a Cisco 2801 that is running IOS 12.4(25g).
Later I purchased an AIM-VPN/SSL-2 .
I read this document on how to enable the AIM card. The document says I should use the crypto engine aim 0 command to enable the card. There is no crypto engine aim command.
http://www.cisco.com/c/en/us/td/docs/ios/12_4t/12_4t11/htvpnssl.html
2801(config)#crypto engine ?
accelerator Crypto hardware device
onboard Onboard Crypto Engine
software Software crypto engine
I can see the card in show diag
AIM Module in slot: 0
Hardware Revision : 1.0
Top Assy. Part Number : 800-27059-01
Board Revision : A0
Deviation Number : 9-5898
Fab Version : 02
PCB Serial Number : FOC12184ZU2
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : AIM-VPN/SSL-2
Version Identifier : V01
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 04 F4 41 01 00 C0 46 03 20 00 69 B3 01
0x10: 42 41 30 80 00 09 17 0A 02 02 C1 8B 46 4F 43 31
0x20: 32 31 38 34 5A 55 32 03 00 81 00 00 00 00 04 00
0x30: CB 8D 41 49 4D 2D 56 50 4E 2F 53 53 4C 2D 32 89
0x40: 56 30 31 00 D9 02 40 C1 FF FF FF FF FF FF FF FF
0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Yet when I look at the crypto engine it is still showing the onboard engine.
sh crypto engine config
crypto engine name: Virtual Private Network (VPN) Module
crypto engine type: hardware
State: Enabled
Location: onboard 0
Product Name: Onboard-VPN
HW Version: 1.0
Compression: Yes
DES: Yes
3 DES: Yes
AES CBC: Yes (128,192,256)
AES CNTR: No
Maximum buffer length: 4096
Maximum DH index: 0150
Maximum SA index: 0150
Maximum Flow index: 0300
Maximum RSA key size: 0000
crypto lib version: 19.0.0
crypto engine in slot: 0
platform: VPN hardware accelerator
Crypto Adjacency Counts:
Lock Count: 0
Unlock Count: 0
crypto lib version: 19.0.0
Also, neither of the AIM LED’s are lit on the front panel of the 2801.
Thanks for any insight.
Tim
Solved! Go to Solution.
03-14-2014 01:23 AM
03-14-2014 01:23 AM
03-14-2014 07:02 AM
Thanks very much Marcin.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide