Troubleshooting PIX PPPoE on 6.3(4)

[matt.austin]

Everyone,

I have a PIX 501, and I am trying to configure it as a PPPoE Client. I used the following configuration:

ip address outside pppoe setroute

ip address inside 192.168.2.1 255.255.255.0

vpdn group PPPoE_Test request dialout pppoe

vpdn group PPPoE_Test localname PPPoE_Test

vpdn group PPPoE_Test ppp authentication pap

vpdn username "SBC Provided username" password "SBC provided password"

I've tried to use the debug pppoe event, error, and packet, but there isn't any type of session attempting to be established. I am at a loss as to why it isn't working. Any suggestions will be greatly appreciated!

Thanks,

Matt

[b.hsu]

Check this link for configuring PPoE in PIX. This will help u in troubleshooting the same

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00801055dd.shtml