Unable to access sites in DMZ when connected over Anyconnect VPN

[alm3323]

Hi everyone, 

I am having an issue where users are unable to access web server addresses/IP addresses when connected using the Anyconnect VPN client but can when the VPN is disconnected. The firewall is a Firepower 1120. I have had a look and NAT for the VPN pool is in hairpin configuration and there is an access control policy allowing VPN users to access all internal LAN resources. If anyone could shed some light on why this might be It would be greatly appreciated!

[MHM Cisco World · Accepted solution]

You need no-NAT (exception)

Not between inside and outside 

But between dmz and outside 

[alm3323]

Thank you for your reply!