10-14-2002 02:52 AM - edited 02-21-2020 12:07 PM
Hi!
I have configured the Cisco 3005 to accept remote connections through an ADSL access.
The problem is that the client wants that some host in the Concentrator´s local lan access to Internet through the same ADSL link using the concentrator as gateway. I configured a filter in the public interface that allowed the default traffic for that public interface plus the rules Incoming HTTP in and outgoing HTTP out. The problem is that i can´t web browse with this configuration in the public interface. Could anyone give me some idea of the rule I should add or the filter to configure?
Thanks in advance,
Best Regards,
Nuria
10-14-2002 04:46 PM
Hi,
Enable NAT globally on the Box, and cnfigure NAT by going to the following link:
Configuration | Policy Management | Traffic Management | NAT | Interface Rules
Choose public (default) filter where this Interface NAT rule applies.
Thanks,
Afaq
10-15-2002 02:33 AM
Hi!
I configured a NAT rule in the public interface and enabled NAT. The problem is that when default public filter is applied to the public ethernet I can´t browse but when I change to a filter that allows any I can browse. I wanted to know which rules do I have to add to the default public filter to browse.
Thanks a lot,
Nuria
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide