I am having issues getting a tunnel up between an ASA5505 and a Linksys BEFSX41
Local ip range of the network with the linksys is 10.1.3.0/24
The local ip range of the network with the ASA is 10.1.2.0/24
Log messages from the ASA
------------------------------------------
IKE Initiator: New Phase 1, Intf inside, IKE Peer 75.151.XXX.XXX local Proxy Address 10.1.2.0, remote Proxy Address 10.1.3.0, Crypto map (outside_map)
AAA retrieved default group policy (DfltGrpPolicy) for user = 75.151.XXX.XXX
Group = 75.151.XXX.XXX, IP = 75.151.XXX.XXX, PHASE 1 COMPLETED
Group = 75.151.XXX.XXX, IP = 75.151.XXX.XXX, Received non-routine Notify message: Invalid ID info (18)
Group = 75.151.XXX.XXX, IP = 75.151.XXX.XXX, QM FSM error (P2 struct &0xd8cf4b38, mess id 0x9ceab897)!
Group = 75.151.XXX.XXX, IP = 75.151.XXX.XXX, Removing peer from correlator table failed, no match!
Linksys
------------
local secure group: IP Range / 10.1.2.1~254
Remote Secure Group: IP Range / 10.1.2.1~254
Remote Security Gateway IP Addr. / 24.154.XXX.XXX
Encryption: 3DES / MD5
Key Management: Auto IKE, PFS OFF, Pre-shared Key: XXXXXXX
Key Lifetime 28800
*Advance Settings*
Phase 1
Operation mode: Main
Proposal 1:
3DES / MD5 / 1024-bit
Key Lifetime 28800
Phase 2
Proposal
Encryption: 3DES / MD5
PFS: OFF
Group: 1024-bit
Key Lifetime: 28800
Other Settings:
NetBIOS broadcast ----- This wont let me uncheck it, every time I do it just re-enables it. Is this the non-routine message reported in the asa log?
I do not have keep-alive checked because when it was the ASA was reporting that the remote device doesnt support keep-alive ???
Im attaching the ASA config
