I've been put in charge of something I've never done before and was wondering if anyone could help.
What I'm doing is trying to connect a 871 router (with advipservices) to our existing VPN router to get a new remote office to work. I've got a little networking background, but most of my experience is in the extreme world, so I'm a little green when it comes to Cisco stuff.
Anyway, the current VPN router is up and it has four VPN's going to it (see command below)
sh crypto isakmp sa
IPv4 Crypto ISAKMP SA
dst src state conn-id slot status
136.x.x.x 206.x.x.x QM_IDLE 1011 0 ACTIVE
136.x.x.x 208.x.x.x QM_IDLE 1005 0 ACTIVE
136.x.x.x 97.x.x.x QM_IDLE 1001 0 ACTIVE
136.x.x.x 216.x.x.x QM_IDLE 1006 0 ACTIVE
I'm trying to add a new VPN from a new DSL connection. The phone company came and installed the DSL on Friday and I was able to assign it a static address we got from the phone company and get on the internet.
I've been fiddling around with the config settings and have gotten to the point where I was able to ping internal network address by IP but not by name (and our Cisco IP phones weren't working), but now I've managed to mess all that up.
Anyway, I've got all of the other configs and I'm trying to figure out where I'm going wrong, but would anyone be able to guide me in the right direction. Right now, when I'm on the new VPN and I do a sh crypto isakmp sa, I get the proper destination and source, but a MM_NO_STATE under the status. I can post some config files tomorrow but any help or at least direction would be greatly appreciated.
Are you responsible for risk management, compliance management and auditing of a network?
If so, we’d like to speak with you to learn your current processes of enforcing compliance and managing risk to help us develop services that will ...
Once you've expanded Cisco Secure Endpoint connector deployment to about 50% of your licensed count (check out this article that shows you how to do that), it's time to put those connectors to action i.e. convert them to Protect from Audit mode for vari...
Hello! I’m Betsy, UX Researcher, on the Cisco+ Secure Connect Now team. Nice to meet you all .We have a short survey to learn about your Zero Trust Network Access (ZTNA) journey. Whether you have, plan to, or have not implemented a ...
A set of interface access rules can cause the Cisco Adaptive Security Appliance to permit or deny a designated host to access another particular host with a specific network application (service). When there is only one client, one host and one se...
How To: Cisco ISE Captive Portals with Aruba Wireless
Authors: Adam Hollifield, Brad Johnson
IntroductionPrerequisitesMinimum RequirementsComponents UsedConfigurationAruba Wireless ControllerWLAN CreationAuthentication ConfigurationRole & Policy Confi...