VPN-client software for IPsec/UDP connection WIN10

[edwin.manders1]

Hi,

I have a working IPsec/UDP VPN connection in WIN7.

For this connection we use:

cisco VPN-Client Version 5.0.07.0290

Now we have a new operating system WIN10.

the Cisco software above is not compatible with WIN10.

I can't install the software.

Cisco advised me to install AnyConnect but with this

AnyConnect i can't configure a IPsec/UDP connection.

Can someone provide my the richt software for

Cisco VPN-Client for WINDOWS 10

Thanx in advance..

Edwin Manders

[jagmeesi]

Hi Edwin,

Cisco VPN client use to have IKEv1/IPsec protocol support where as IPsec is still supported on AnyConnect but it uses IKEv2 instead, so to answer i would say AnyConnect Supports IPsec Over NAT i.e  IPsec/UDP, its just that uses an advanced version of Key Management Protocol i.e IKEv2.

Refer the following for the sample:

https://supportforums.cisco.com/document/74111/asa-anyconnect-ikev2-configuration-example

http://www.networkgalaxy.org/2013/07/ikev2-ipsec-remote-access-vpn-with.html

http://cyruslab.net/2014/11/18/cisco-asa-setting-up-anyconnect-vpn-with-ssl-and-ipsec/

Regards

Jagmeet