VPN Connected but no traffic passing thru - Cisco RV325

[raz.reyes]

Hello,

Just setup Site to Site VPN  between Site A to B (both Cisco RV325 on 2 sites). first, I got everything working the other day - i can ping from both side and even RDP to the servers from the other side, but after a day, all failed. I still get the status as "Connected" at both ends but no traffic seems to pass thru. 

Done some ACLs to allow IPSec (UDP 500) and ESP port 50, but to no avail.All config looks good from both sites. Please help

Thanks.

thenetguy

[Deepak Kumar]

Hi,

Please check your Static routing and ACL configuration. 

If you enable to find issue then send debug and configuration to me.

Regards,

Deepak Kumar

www.deepuverma.in