vpn dynamic-map

[bma]

Hi

I am using pix515, cisco vpn client 1.1 for VPN users. Some users get connetion slow problem, about to ping several times, then can make tunnel ok. From vpn clinet 1.1 log view, can get phase 2 time out message when it has problem. is it dynamic-map problem? if use static map, can it be fixed? or depends on internet traffic?

Thanks

ben

[ciscomoderator]

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.