I have a new RV180 with the latest firmware I can find, and a new RV042v3 with the latest firmare I can find. On the RV042v3, I factory defaulted it after the new firmware, restored from backup, removed the tunnel, and put it back again. I have three tunnels up and running on the RV180, one with an old Zywall 2 and two with RV042v1. I am unable to remote manage either the RV180 or the RV042v3, so working a vpn between them is pretty tedious. I had a tunnel from the RV042v3 to a Zywall 2 Plus, but I cannot get a tunnel to work with the RV180. I am using fixed ip on both ends, gateway to gateway, aes-128/sha-1/dh2/28800 and 3600, with a good long key. The default firewall is on in both, I tried turning the firewall off on the RV042v3 and connecting, nogo. It feels like the RV180 just doesn't want to do more than three, but I disabled the three working ones and tried, and still nogo. So two questions, how do I set (other than the firewall settings) the RV180 and RV042v3 for remote management, and your thoughts about cannot tunnel. There is also another Zywall that I can't get to right now trying to connect to the RV180, so the log file is pretty messy. Thanks!!!
