VPN setup between 2610 & Raptor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-23-2002 06:24 PM - edited 02-21-2020 12:15 PM
We are having problem setting up the VPN. The crypto map is applied on the frame relay sub interface and the peer is the address of the raptor outside interface which is behind another router (where the other PVC terminates).
We tested the connectivity prior to the setup and ipsec requests are being sent and received by raptor but we coulnd't make it work.
Question: is there anything special that I need to do when configuring a VPN on frame relay sub-interface?
Below is the result of the debug.
*Dec 24 16:15:35.513: ISAKMP (0:1): peer does not do paranoid keepalives.
*Dec 24 16:15:35.513: ISAKMP (0:1): deleting SA reason "gen_ipsec_isakmp_delete
but abc isakmp" state (I) MM_NO_STATE (peer 9.9.9.9) input queue 0
*Dec 24 16:15:35.517: ISAKMP (0:1): deleting SA reason "gen_ipsec_isakmp_delete but abc isakmp" state (I) MM_NO_STATE (peer 9.9.9.9) input queue 0
Any suggestions is appreciated.
Merry Christmas to all and thanks in advance.
- Labels:
-
Other VPN Topics

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-23-2002 11:22 PM
Hi,
There is nothing special when you apply the crypto map to the frame relay sub interface.
If the Isakmp and IPSec policies match on both the VPN Servers and the necessary ports and protocols are open, then your IPSec tunnel should work without any issues.
Regards,
Arul
