VPN Tunnel (IPsec) between two Routers

[22cc0127]

Hello, I would like to create a VPN Tunnel between HQ1 and HQ2 for Valn11 (Network 192.168.27.128/26 and 192.168.28.128/26).

I checked the settings a couple of times but it seems that the VPN Tunnel did not work.

The setting have done when checking with show crypt map command and show run.

However, When I ping H3 (192.168.28.130) by H1 (192.168.27.130) and checking with show crypt ipsec sa command, there are no pocket are transferred from VPN Tunnel.

Can anyone tell me where I made a mistake please.

[MHM Cisco World]

share the config here, I can not open zip file 

[Martin L]

it works one way only; from H3 to H1 or from right side to left, but not other way;  You have NAT on one side, left side but not on right side, another company; normally ISP will not route any private range subnet like yours 192.168.x.x, so you would need NAT/PAT on both sides.  Anyway, I am not sure if NAT/Pat is set up correctly. 
Since this is PT simulator, be care full adding too much to this lab; not sure if u can run NAT/PAT with IPsec.

Regards, ML
**Please Rate All Helpful Responses **

[22cc0127]

Thank you!! I tried to NAT/PAT on right side and it's work!!